Santec TSL-710 - Page 97

Tunable Semiconductor Laser TSL-710
7-43
[:SOURce][:WAVelength]:FREQuency:SWEep:STOP
Syntax [:SOURce][:WAVelength]:FREQuency:SWEep:
STOP<wsp><value>
Description Sets the sweep end frequency.
Parameter Range: Frequency tuning range (THz)
Step：0.00001 (THz)
Response None
Example :FREQ:SWE:STOP 199.8616
Sets the sweep end frequency to 199.8616 THz.
[:SOURce][:WAVelength]:FREQuency:SWEep:STOP?
Syntax [:SOURce][:WAVelength]:FREQuency:SWEep:STOP?
Description Reads out the sweep end frequency.
Parameter None
Response Range: Frequency tuning range (THz)
Step：0.00001 (THz)
Example : FREQ:SWE:STOP?
→ 199.8616
Indicates that the sweep end frequency is
199.8616 THz.
[:SOURce][:WAVelength]:FREQuency:SWEep:STEP[:WIDTh]
Syntax
[:SOURce][:WAVelength]:FREQuency:SWEep:
STEP[:WIDTh]<wsp><value>
Description Sets the step interval (frequency) of step sweeps.
Parameter Range：0.00002 〜 19.76219 (THz)
Step：0.00001 (THz)
Response None
Example :FREQ:SWE:STEP 0.01
Sets the step interval (frequency) to 0.01 THz.
[:SOURce][:WAVelength]:FREQuency:SWEep:STEP[:WIDTh]?
Syntax [:SOURce][:WAVelength]:FREQuency:SWEep:
STEP[:WIDTh]?
Description Reads out the step interval (frequency) of step sweeps.
Parameter None
Response Range：0.00002 〜 19.76219 (THz)
Step：0.00001 (THz)
Example :FREQ:SWE:STEP?
→ 0.010
Indicates that the step interval (frequency) is 0.01 THz.