Sanyo PLC-WU3800 - Computer Input; Auto PC Adjustment

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
32/74
8.7.6 CF_VPOS Command
Command “CF_VPOS_%1”[CR]
%1
“015” --------- +15
“014” --------- +14
  ：
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
  ：
“-14” ---------- -14
“-15” ---------- -15
“UP” ---------- Vertical Position setting value + 1
“DN” ---------- Vertical Position setting value – 1
Details
Set Vertical Position
This command is available in normal Power ON status.
Note1) Screen mode is changed into Custom by receiving this command.
Note2) When there is no Input, projector returns 101 and the command does not
execute.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.7.7 CF_HSCALE Command
Command “CF_HSCALE_%1”[CR]
%1
“032” --------- +32
“031” --------- +31
  ：
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
  ：
“-31” ---------- -31
“-32” ---------- -32
“UP” ---------- Horizontal Scale setting value + 1
“DN” ---------- Horizontal Scale setting value - 1
Details
Set Horizontal Scale
This command is available in normal Power ON status.
Note1) Screen mode is changed into Custom by receiving this command.
Note2) When there is no Input, projector returns 101 and the command does not
execute.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]