Sanyo PLC-WU3800 - CR_CCAPTIONCOLOR Command; CR_RCODE Command; CR_SECURITY Command; CR_KEYDIS Command

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
68/74
Response
Acceptable “000_%a”[CR]
％a
“OFF” --------- Off
“CC1” --------- CC1 is selected
“CC2” --------- CC2 is selected
“CC3”--------- CC3 is selected
“CC4” --------- CC4 is selected
Unacceptable “Error Code”[CR]
9.11.21 CR_CCAPTIONCOLOR Command
Command “CR_CCAPTIONCOLOR”[CR]
Details Get selected color of Closed caption
Response
Acceptable “000”[CR]
%a
“COLOR” ------- Color is selected
“WHITE” -------- White is selected
Unacceptable “Error Code”[CR]
9.11.22 CR_RCODE Command
Command “CR_RCODE”[CR]
Details Get selected Remote Control Code
Response
Acceptable “000_%a”[CR]
%a
“001” --------------------------- Code1 is selected
“002” --------------------------- Code2 is selected
Unacceptable “Error code”[CR]
9.11.23 CR_SECURITY Command
Command “CR_SECURITY” [CR]
Details Get Security Mode setting status
Response
Acceptable “000_%1[CR]
%1
“ON” ------------- PJ Lock setting on Menu is ON-1 or ON-2
“OFF” ------------PJ Lock setting on Menu is OFF
Unacceptable “Error Code” [CR]
9.11.24 CR_KEYDIS Command
Command “CR_KEYDIS”(CR)
Details Get disability status of RC/Projector keys (valid or invalid)
Response
Acceptable “000_%a”[CR]
%a
“NONE” -------------------------- RC / Projector keys are valid
“RC” ------------------------------ RC keys are invalid
“KEY” ----------------------------- Projector keys are invalid
Unacceptable “Error code”[CR]
9.11.25 CR_PJLOCKNOW Command
Command “CR_PJLOCKNOW” [CR]
Details Get if PJ lock is actually in operation
Response Acceptable “000_%1[CR]