Sanyo PLC-WU3800 Manual

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
71/74
9.12 Other Status Read Command
9.12.1 CR_STATUS Command
Command “CR_STATUS”(CR)
Details
Get status of Projector behavior.
This command affects the same as ”CR0” of Basic Serial command, but this has
an error code.
Response
Acceptable “000_%1”[CR]
%1
“00”= Power ON
“80”= Stand by
“40”= Count down
“20”= Cooling down
“10”= Power failure
“28”= Cooling down due to abnormal temperature
“88”= Stand by after Cooling down
“24”= Power saving cooling down
“04”= Power saving
“21”= Cooling down due to Lamp failure
“81”= Stand by after Cooling down due to Lamp failure
Unacceptable “Error Code”[CR]
9.12.2 CR_SIGNAL Command
Command “CR_SIGNAL”(CR)
Details Get Signal status if there is signal or not
Response
Acceptable “000_%a”[CR]
%a
“ON” ------------------------ Signal is found
“OFF” ----------------------- There is no signal
Unacceptable “Error code”[CR]
9.12.3 CR_VMUTE Command
Command “CR_VMUTE”[CR]
Details Get setting status of No Show
Response
Acceptable “000_%a”[CR]
%a
“ON” -------- No Show is ON
“OFF” ------- No Show is OFF
Unacceptable “Error code”[CR]
9.12.4 CR_FREEZE Command
Command “CR_FREEZE”[CR]
Details Get setting status of Freeze
Response
Acceptable “000_%a”[CR]
%a
“ON” ---------------------- Freeze is ON
“OFF” --------------------- Freeze is OFF
Unacceptable “Error code”[CR]

Sanyo PLC-WU3800 Specifications

General

Matrix size	0.59 \
Projection distance	0.99 - 12.1 m
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	500:1
Screen size compatibility	40 - 300 \
Projector native resolution	WXGA (1280x800)
Keystone correction, vertical	±40 °
Audio input	2
Aspect ratio	16:10
Network ready	Yes
Power supply type	AC
Dimensions (WxDxH)	335.7 x 257.5 x 93.6 mm
Connectivity technology	Wired
Focus	Manual
Digital zoom	16 x
Focal length range	19.2 - 30.2 mm
Noise level	35 dB
Noise level (economic mode)	31 dB
Dot clock scanning frequency	140 MHz
Lamp type	NSHA
Lamp power	275 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
DVI port	No
Composite video in	-
Serial interface type	RS-232
USB 2.0 ports quantity	0
Supported video modes	1080i, 1080p, 720p
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL M, PAL N, SECAM
Supported graphics resolutions	1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 800 (WXGA), 1400 x 1050 (SXGA+), 1600 x 1200 (UXGA), 1920 x 1200 (WUXGA), 640 x 480 (VGA), 800 x 600 (SVGA)
Product color	White
AC input voltage	100 - 240 V
Power consumption (standby)	0.7 W
Power consumption (typical)	317 W
Power consumption (PowerSave)	280 W
Cables included	VGA

Weight and Dimensions

Depth	257.5 mm
Width	335.7 mm
Height	93.6 mm
Weight	3500 g