Sanyo PLC-WU3800 - Appendix; Troubleshooting Guide

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
67/74
9.11.15 CR_PIPPOSITION Command
Command “CR_PIPPOSITION” [CR]
Details Get position of Subpicture in Picture in Picture
Response
Acceptable “000_%1”[CR]
%1
“BTMRIGHT” -------------- Subpicture is Bottom right
“BTMLEFT” ---------------- Subpicture is Bottom left
“TOPRIGHT” -------------- Subpicture is Top right
“TOPLEFT” ---------------- Subpicture is Top left
Unacceptable “Error code”[CR]
9.11.16 CR_STANDBYMODE Command
Command “CR_STANDBYMODE” [CR]
Details Get Standby Mode setting status
Response
Acceptable “000_%a”[CR]
%a
“ECO” -------------- Eco Mode
“NORMAL” -------- Network Mode
Unacceptable “Error code”[CR]
9.11.17 CR_P-MANE Command
Command “CR_P-MANE”[CR]
Details Get Power management setting status
Response
Acceptable “000_%a”[CR]
%a
“OFF” -------------------------- Power Management is OFF
“READY” ---------------------- Power Management is Ready
“SHUTDOWN” ---- Power Management is set to Shut Down mode
Unacceptable “Error code”[CR]
9.11.18 CR_P-MANETIME Command
Command “CR_P-MANETIME”[CR]
Details Get time to start Power Management
Response
Acceptable “000_%a”[CR]
%a “001”~”030” -----------------------1 minute to 30 minutes
Unacceptable “Error code”[CR]
9.11.19 CR_ON-STA Command
Command “CR_ON-STA”[CR]
Details Get Direct on setting status
Response
Acceptable “000_%a”[CR]
%a
“ON” -------------------------- Direct on is ON
“OFF” ------------------------ Direct on is OFF
Unacceptable “Error code”[CR]
9.11.20 CR_CCAPTIONDISP Command
Command “CR_CCAPTIONDISP”[CR]
Details Get selected channel of Closed caption