Sanyo PLC-WU3800 - Computer Input; Manual PC Adjustment

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
33/74
8.7.8 CF_HPOS Command
Command “CF_HPOS_%1”[CR]
%1
“015” --------- +15
“014” --------- +14
  ：
“002” --------- +2
“001” --------- +1
“000” --------- +0
“-01” ---------- -1
“-02” ---------- -2
  ：
“-14” ---------- -14
“-15” ---------- -15
“UP” ---------- Horizontal Position setting value + 1
“DN” ---------- Horizontal Position setting value - 1
Details
Set Horizontal Position
This command is available in normal Power ON status.
Note1) Screen mode is changed into Custom by receiving this command.
Note2) When there is no Input, projector returns 101 and the command does not
execute.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]