Sanyo PLC-WU3800 - Setting; Language and Menu Position; Auto Setup Configuration

PLC-WU3800 Expand Serial Command Functional Specifications
                                       
46/74
8.11 Other Command
8.11.1 CF_KEYENU Command
Command “CF_KEYENU_%1”[CR]
%1
“RIGHT” ------------------------- Shift Pointer on OSD Menu to right
“LEFT” --------------------------- Shift Pointer on OSD Menu to left
“UP” ------------------------------ Shift Pointer on OSD Menu to right
“DN” ------------------------------ Shift Pointer on OSD Menu to right
“SELECT” ----------------------- Behave the same as Select key of Remote control
“AUTOPC” ---------------------- Execute Auto PC adj
Details
This command behave the same as corresponding keys of Projector
Once Auto PC adj. is started with “AUTOPC” command, it does not stop with
receiving the command another time.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.11.2 CF_MENU Command
Command “CF_MENU_%1”[CR]
%1
“ON” ----------------------------- Display OSD Menu
“OFF” --------------------------- Cancel OSD menu
Details
Display / Cancel On Screen Display Menu
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]
8.11.3 CF_POWER Command
Command “CF_POWER_%1”[CR]
%1
“ON” ------------Power ON projector
“OFF” ---------- Power OFF Projector
Note1) Countdown can be terminated by sending this command.
Note2) Projector returns error code due to unable of command execution depends
on its condition.
Note3) Although projector returns “OK”, operation may not be proceeding properly.
(e.g. After returning “000” for Power ON command, projector gets abnormal
temperature.) Use Status read command to get projector states.
Details Power ON / OFF projector.
Response
Acceptable “000”[CR]
Unacceptable “Error Code”[CR]