Sartorius Mark 3 - Functions available from the Standby screen

Functions available from the Standby screen:
§ Press Start|Stop key to initiate a test
§ Press Recall soft key to change the program to be
used for testing a sample
§ Press User soft key to select an operator name
(feature must be turned on in Setup)
§ Press Setup soft key to enter the Setup menu in
order to make all parameter changes
§ Press Graph soft key to display a graph
§ Press Weigh soft key to use as a balance
Standby-Temperature
!
with a New Program
When creating a new program, the standby tem-
perature setting from the previous drying program
is used automatically by the analyzer�
Example:
You have created a new program for drying
a temperature-sensitive sample at low temperature�
The analyzer uses the standby temperature, e�g�
165°C, from the previous program�
You must call up the standby temperature param-
eter and change the temperature value� Ifyou for-
get performing this setting, your analyzer is always
too hot before starting the test�
23