Sartorius Mark 3 - To deactivate security; Setup Security Access

63
To deactivate security:
§ From the Setup menu screen press the 8 key or high-
light Security and press the Enter key�
§ Type the set pass code and press the Enter key�
The security protection of the analyzer will now be
deactivated�
Setup Security Access
Sections of the analyzer setup configuration and other
features can be security protected with the pass code at
the discretion of the primary operator�
To set up security access:
§ If security is On, first deactivate security as described
above�
§ From the Security menu screen, press the 2 key or high-
light “Set up security access” and press the Enter key to
display the Security access screen�
§ From the list of features, select either On or Off to acti-
vate or deactivate, respectfully, each feature�
§ Press the respective number key to toggle On or Off, or
highlight the selection and press the On|Off soft key�
§ Press the Arrow soft key to return the Security menu�
§ Security must be set On in the Security menu to acti-
vate�
Note
If a selection from the Security access list is activated
(showing On next to the listing in the Security access
screen) and the security mode has been enabled under
“Set pass code On|Off,” then when
an operator tries to enter this selection, the Pass code
screen will appear� The only way to enter this selec-
tion is to enter the correct pass code which deactivates
security�
1) Program manage: On
2) Data log: On
3) Modify operators: On
4) Results printout format:On
5) Time and date: On
6) Communication ports: On
7) Conserve mode: On
9) Audio & video: On
0) Service On
Security access
09/07/2012 02:14 PM
On/Off