Caution
Do not touch the metal surfaces inside
the drying chamber while removing
or placing a sample in the analyzer since
the surfaces are very hot�
Do not touch the heater hood ventila-
tion area at any time because this area
can be hot during and after a test�
§ Do not test flammable or toxic
materials�
§ Use the analyzer in a fume hood if the
samples emit fumes which could be
harmful�
§ Know where the fire extinguisher is
located� Use only an extinguisher rated
for use with electrical fires�
§ Keep the analyzer clean� Always unplug
the analyzer and cool it thoroughly
before cleaning or performing service�
§ Do not block the ventilation areas of
the heating chamber�
§ If necessary, press the Start|Stop key
during a test to stop the test�
§ Locate the analyzer away from
flammable materials�
§ If liquid is spilled into the analyzer,
unplug the Heating Module from the
electrical supply immediately�
§ Analyzer is suitable for continuous
operation
Safety Precautions
Danger
Use of this product in a manner
not specified by the manufacturer
may impair any safety protection
provided by the equipment!
Every attempt has been made to
make this analyzer safe and easy to
use� However, like any laboratory
instrument respect must be given
to the operation of the analyzer
due to environmental conditions,
the nature of the samples being
tested and of the chemicals which
might be near the analyzer�
To avoid personal injury or damage
to the analyzer, please observe the
following precautions:
Read all instructions in the Operat-
ing Instructions prior to operating
your analyzer�
Warning
Control module contains 3V Lith-
ium Battery� Please dispose of in
accordance with local regulations
and conventions�
7
To Next Page
Loading...
