79
Syringe Mode (LMA100P only)
When testing samples with a highly
volatile component such as paint, to
achieve the most accurate results it is
desirable to use the LMA100P syringe
mode� This mode consists of obtaining
the initial sample weight by recording
the difference between a syringe full
of sample and after sample has been
dispensed� Results are displayed in the
selected unit�
To select syringe mode:
§ Press the 9 key from the Program menu
to display the Mode screen�
§ Press the 2 key for Syringe� The display
will return to the Program menu�
To test samples in the Syringe mode:
§ Open the heater hood, place a sample
pad on a pan and close the hood�
§ Press the Start|Stop key to begin a test�
§ The analyzer will automatically tare the
pan and sample pad�
§ At the prompt, open the hood and
remove both the pan and pad� Then
place the full syringe on the pan sup-
port and close hood� The analyzer will
take the full weight of the syringe with
sample�
§ At the prompt, remove the syringe from
the pan support�
§ At the prompt, replace the pan and pad�
Then add sample to the pad�
§ At the prompt, remove the pan and pad�
§ At the prompt, place the empty syringe
back on the pan support, close hood�
The analyzer will now read the empty
syringe weight�
§ At the prompt, remove the empty
syringe�
§ At the prompt, replace the pan with
sample on the pad back onto the pan
support and close the hood to start the
test�
§ The analyzer will enter the test mode�
When the test is done, the results will be
reported in the selected unit�
Note
If for some reason the automatic
transition in the steps of the syringe
mode does not advance to the next
step, the Enter key may be used to
advance the step�
To Next Page
Loading...
Need help?
General
