– LMA100P: 300 drying programs
– LMA110S: 60 drying programs
Recalling a Program
Drying programs are stored for easy access at a later
time� This eliminates the need to change parameters for
frequently tested samples� Following drying
programs can be stored:
Creating and storing a program is described under
Developing a Drying Program�
To recall a stored program, perform the following steps:
1� From the Standby screen, press the RECALL soft key�
The screen will change to the first page of stored pro-
grams as show below�
2� To display programs on the next pages, press the Down
soft key�
3� Press the number(s) key followed by the Enter key for
the number that precedes the program name�
As an alternative, use the arrow keys to highlight the
desired program name, then press Enter� The display
will change to the Standby screen with the new
program in the top left corner� This program will be
used for the next test� If a blank program is entered, the
analyzer will use the last valid program that
was entered�
Note
As a shortcut, it is not necessary to have the desired
program listed on the display to recall it� Simply enter
the desired number from your memory on the first page
and press the Enter key�
25
14)
2)
Whey Protein 15)
)61 )3
)71 )4
)81 )5
)91 )6
)02 )7
)12 )8
)22 )9
)32 )01
)42 )11
)52 )21
)31 26)
Programs
Program #:
09/07/2012 02:14 PM
Down
1)
Dry Milk Powder
Up
_
Top
To Next Page
Loading...
