Satel Versa - Parameters Related to Communication between the Control Panel and DLOADX Program; Communication Identifiers; Modem Communication Parameters

20 VERSA SATEL
3.2 Parameters related to communication between the control panel and
DLOADX program
3.2.1 Communication identifiers
Communication identifiers are necessary for all methods of communication.
Programming the communication identifiers
You can program the communication identifiers:
 DLOADX program: “Identifiers and tel. no” window (the command for opening this window
is available in the “Communication” menu; you can also use the Ctrl+R key combination).
 keypad: functions available in the SRVMOD CONFIG submenu (SERVICE MODE 0. SRVMOD
CONFIG
).
You can skip programming the communication identifiers in DLOADX program in the
following cases:
 the control panel identifiers have their factory default value – after establishing connection,
a prompt will be displayed asking you to write randomly generated identifiers to the control
panel and the program (you can accept them or enter your own ones),
 communication is effected through the control panel RS-232 (TTL) port and the control
panel is running in the service mode – after establishing connection, the DLOADX program
will read the identifiers programmed in the control panel.
Description of communication identifiers
VERSA identifier – identifier of the alarm control panel. It consists of 8 characters (digits or
letters from A to F). It enables the DLOADX program to recognize the control panel and
match the data file to it, provided the data file has been written to the computer. Do not
program the same identifier for different control panels which are operated from the same
computer (the DLOADX program will be incapable of distinguishing between them).
DLOADX identifier – identifier of the computer with DLOADX program. It consists of 8
characters (digits or letters from A to F). It enables the control panel to recognize the
computer with DLOADX program.
Communication between the DLOADX program and the control panel is possible, if identical
identifiers are programmed in the program and the control panel.
3.2.2 Modem communication parameters
Programming the parameters
Telephone numbers
You can program the telephone numbers:
 DLOADX program: “Identifiers and tel. no” window (the command for opening this window
is available in the “Communication” menu; you can also use the Ctrl+R key combination).
 keypad: functions available in the SRVMOD CONFIG submenu (SERVICE MODE 0. SRVMOD
CONFIG
).
DLOADX program settings
You can configure the modem communication settings in the “Configuration” window,
“Modem” tab.