Satel Versa - Finishing Local Programming; Remote Programming; Programming Via Modem

SATEL VERSA 23
4. Establish communication between the control panel and the program in one of the
following ways.
Establishing communication with verification of identifiers
Use the keypad to start the local programming function [START DWNLRS]:
1. Enter the service code and press .
2. Press in turn .
Establishing communication without verification of identifiers
If no communication identifiers have been programmed in the DLOADX program, use the
keypad to enter the service mode:
1. Enter the service code and press .
2. Press in turn . The service mode will be started and, additionally, the
local programming function will be started [START DWNLRS].
Emergency communication establishing procedure (“from pins”)
If the control panel does not support keypads, does not accept the service code, etc., start
the service mode “from pins” (see: “Starting the service mode “from pins”” p. 5). The local
programming function [START DWNLRS] will be started automatically.
3.3.2 Finishing local programming
You can finish the local programming function from the keypad by using the FINISHDWNLRS
function (enter the service code and press , and then press in turn ).
The local programming function will be finished automatically 4 hours after communication
with the DLOADX program is ended.
3.4 Remote programming
3.4.1 Programming via modem
Modem communication can be established in one of the following ways:
1. Connection initialized from the DLOADX program. The control panel can be programmed
from any location.
2. Connection initialized from the DLOADX program, but the control panel calls back and
sets up the connection. The control panel can only be programmed from a defined
location.
3. Connection initialized by the control panel. The control panel can only be programmed
from a defined location. This method should be used when the system user does not want
the remote programming to take place without his knowledge.
Initiating a modem connection from DLOADX program
Control panel settings:
 do not program the telephone number of modem connected to computer!
 enable ANSWERING – MODEM option (see: “Global options” p. 27),
 define the number of rings after which the control panel will answer incoming calls – RINGS
BEFORE ANSWER
(see: “Other global parameters” p. 31),
 enable the DOUBLE CALL option if the control panel is to answer only after the second call
(see: “Global options” p. 27).