66 VERSA SATEL
energy save (available in some detectors) – after sending information on violation, the
detector will not send any further information about violations for 3 minutes (the zone will
be violated for 2 seconds after the controller receives the transmission containing
information on detector violation).
8.6 Proximity card arm/disarm device
Fig. 19. DLOADX program: configuring the proximity card arm/disarm device.
LED R – reaction of the partition after removal of the card from the device, when the red LED
is lit. The partition can be fully armed or its status may remain unchanged.
LED G / LED Y – reaction of the partition after removal of the card from the device, when the
green / yellow LED is lit. The partition can be armed in one of three modes, it can be
disarmed or its status can remain unchanged.
In the DLOADX program, to define reaction of the partition after moving the card away
from the module, double click on the field corresponding to the selected partition. The
icon displayed in the field will change accordingly. In the LCD keypad, select the
partition response from the list.
Options
Alarm signal – if the option is enabled, the device is audibly signaling alarms during the
K
EYPAD’S ALARM TIME.
until canceled – if the option is enabled, the device is audibly signaling the alarm memory.
3 wrong cards alarm – if the option is enabled, reading the unknown card code three times
by the device will trigger alarm.
Sign. entry delay – if the option is enabled, the device is audibly signaling the entry delay
countdown.
Sign. exit delay – if the option is enabled, the device is audibly signaling the exit delay and
auto-arm delay countdown.
Sign. card (hardware) – if the option is enabled, the device is signaling by a single beep that
the card code has been read out or the LED has lit up (the code will be sent to the control
panel after removal of the card and only then the device will audibly signal its reaction to
the read code).
To Next Page
Loading...
