Satel Versa - Glossary of Terms

SATEL VERSA 5
1. Introduction
The VERSA alarm system can be configured by using:
 keypad,
 computer with DLOADX program installed (locally or remotely).
Local programming (using the keypad or DLOADX program) is possible, if one the following
conditions is met:
 PERMANENT ACCESS option is enabled (SERV. ACCESS user function ([code]
0. SERVICE 5. SERV. ACCESS) – see: USER MANUAL) – the option is enabled by default,
 access to the control panel has been granted temporarily to the service personnel (ACCESS
TIME
user function ([code] 0. SERVICE 6. ACCESS TIME) – see: USER MANUAL).
As required by the standards, the service access after completion of the installation
has to be limited by the administrators.
2. Configuring the control panel with keypad
The control panel can be programmed using the functions available in the service mode. In
case of the LED keypad, programming is subject to some limitations (e.g. entering names is
impossible). Programming the control panel by use of LED keypad is not recommended
by SATEL.
The service mode is indicated on the keypads by means of the LED. The LED is lit on
the keypad in which the service function menu is available, while it is blinking on all the other
keypads. The service mode may also be signaled acoustically, after the corresponding option
is enabled. Additional information is provided by the LED, which is:
– blinking during navigation throughout the menu and submenus,
– lit when any service function is running.
When in the service mode, the alarm system signals no alarms.
2.1 Starting the service mode
1. Enter the service code (by default: 12345) and press the key.
2. Press in turn . The service mode will be started.
2.2 Starting the service mode “from pins”
When entering the service mode in the normal way is not possible (the control panel does not
support keypads, does not accept the service code, etc.), you can use the emergency
procedure, so-called, starting “from pins”.
1. Power off the control panel (disconnect AC mains first, and the battery next).
2. Place a jumper across the RESET pins.
3. Power up the control panel (first connect the battery and then the AC power).
4. Wait a few seconds and remove the jumper from the RESET pins. The control panel will
enter the service mode. The service mode menu will be available on the keypad with the
lowest address (in the case of the wireless keypad, the menu will be displayed after
pressing any key).