Satel Versa - Timer Parameters; 10 Reporting; Configuring the Reporting; Reporting Parameters and Options

68 VERSA SATEL
9.2 Timer parameters
Name – individual timer name (up to 16 characters).
Weekly schedule – the time of starting/ending timer for each day of the week and everyday
(the timer can be started/ended twice a day: according to the settings scheduled for the
given day of the week and according to the everyday settings).
Exception – the period during which the timer will be started/ended at a different time than
indicated in the weekly schedule. 4 exceptions can be programmed for a timer. You can
program for each exception:
– the date from which the exception will apply,
– the date to which the exception will apply,
– the timer start/end time when an exception applies.
Partition arming mode – the arming mode that will be activated in the partition when the
timer will start.
10. Reporting
The control panel can send event codes to the monitoring station by using the following
transmission paths:
 analog telephone line [built-in analog telephone communicator],
 Ethernet network [requires the ETHM-1 / ETHM-1 Plus module to be connected].
If both transmission paths are used, the control panel will first try to send the event code
through the Ethernet network, and only when the attempt fails, it will switch over to the
telephone reporting.
10.1 Configuring the reporting
You can configure the reporting parameters and options:
 DLOADX program: “VERSA – Reporting” window.
 functions available in the M
ONITORING submenu (SERVICE MODE 5. MONITORING).
All parameters and options of reporting can only be configured by means of the
DLOADX program.
10.2 Reporting parameters and options
REPORTING – TELEPHONE and REPORTING – ETHM options are described in the “Global
options” section (p. 27).
10.2.1 Options
Station 1 or 2 – select this option if the control panel is to send event codes to Station 1, and
in the case of failure – to Station 2.
Station 1 – select this option if the control panel is to send event codes to Station 1 only.
Station 2 – select this option if the control panel is to send event codes to Station 2 only.
Station 1 and 2 – select this option if the control panel is to send event codes to both
monitoring stations.
Events amount limiting – if the option is enabled, events from the same source are saved
into the event log and reported to the monitoring station 3 times only. This option does not
apply to the alarms from zones (see: A
UTO-RESET 3 or AUTO-RESET 1 zone option).