Satel Versa - Station 1; Station 2

SATEL VERSA 69
Report module restarts – if the option is enabled, in case of sending event codes in Contact
ID or SIA format, the monitoring station is informed about module restarts.
Restore after bell – if the option is enabled, the zone restore code will only be sent to the
monitoring station after the alarm signaling ends. If a few outputs are signaling alarm, the
zone restore code will be sent when one of them stops signaling the alarm.
Restore after disarm – if the option is enabled, the zone restore code will only be sent to the
monitoring station after disarming the partition to which the zone belongs.
Fig. 21. DLOADX program: “Monitoring Stations” tab in “VERSA – Reporting” window.
10.2.2 Station 1 / Station 2
Reporting format – format in which event codes are sent to the monitoring station.