SATEL VERSA 75
By means of the MSG.CLR.CODES user function ([code] 6. SETTINGS
5. MSG.CLR.CODES), the users having the PROGRAMMING right can edit the codes for
acknowledging / clearing notification.
User – the user assigned to the phone number. If the user has the INT-VG ACCESS right and
the INT-VG module is connected to control panel, he will get automatically access to the
voice menu after acknowledging the voice notification.
11.1.3 Event assignment
Specify for the events, the occurrence of which is to be notified by the control panel:
telephone numbers that will be notified,
number of the message to be sent. You can assign the text message number to an event.
In the case of voice notifications, the voice message assigned to that text message will be
used.
11.1.4 SMS/Pager messages
You can program up to 64 text messages that will be used for notification. You can assign a
voice message to each text message. The text messages are numbered from 1 to 64. The
voice messages are numbered from 0 to 15 (INT-VG module / CA-64 SM expander can play
back up to 16 voice messages). The same voice message can be assigned to several text
messages.
For PAGER messaging, define the pager identification parameters.
11.1.5 Starting the telephone messaging
1. Enable the TELEPHONE MESSAGING option (see: “Global options” p. 27).
2. Define the number of attempts made by the control panel to notify about the event
(parameters ROUND COUNT and RETRIES NO. FOR ONE ROUND).
3. Enter the phone numbers that are to be notified, and description of those phone numbers.
4. Specify, of which events, which phone numbers and by means of which messages the
control panel is to notify (remember that a text message number is assigned to each
event, and the voice message assigned to that text message will be used for voice
notification).
5. Determine whether alarm clearing should cancel the messaging (global option CLEAR
MESSAGING ON ALARM CLEARING
).
6. Configure the global options related to telephone communicator:
– determine how the telephone numbers should be dialed (TONE DIALING; in case of the
pulse dialing option – P
ULSE 1/1,5 (OFF 1/2)),
– determine whether the control panel, prior to dialing the number, should check the
telephone line for dialing signal (NO DIAL TONE TEST),
PAGER / SMS messaging
1. Select PAGER1 or PAGER2 as the messaging type for the phone number to be notified.
2. Enter the content of messages that are to be used for notification.
3. Define the pager identification parameters (PAGER1 factory settings are configured for
sending the message as SMS message via the SATEL GSM module).
Voice messaging
1. For the telephone number to be notified:
– select voice messaging as the type of notification,
To Next Page
Loading...
