SATEL VERSA 27
4.2 Global options
Reporting – TELEPHONE – if the option is enabled, the control panel can send event codes
to the monitoring station by means of the telephone line.
Reporting – ETHM – if the option is enabled, the control panel can send event codes to the
monitoring station over Ethernet.
Telephone messaging – if the option is enabled, the control panel can notify about the
occurrence of specific events by means of voice or text messages using the phone
communicator.
Answering – modem – if the option is enabled, external initiation of the modem
communication with the control panel is possible.
Double call – if the option is enabled, you must call the control panel twice to be connected.
The first time, wait for the preset number of rings and then hang up. Then call again within
three minutes and the control panel will answer the call immediately. This solution makes it
possible to connect after the control panel some additional devices which will be activated
after a preset number of rings (e.g. answering machine, fax, etc.).
Tone dialing – if the option is enabled, the control panel will tone dial the telephone numbers
(pulse dial, if this option is disabled).
Pulse 1/1.5 (off 1/2) – this option applies to pulse dialing. Before you enable it, make
yourself familiar with the valid standard of pulse dialing.
No dial tone test – if the option is enabled, the control panel will not perform the test for dial
tone before dialing the number and will start dialing the number 5 seconds after going “off
hook”. This makes it possible for the control panel to dial the number when some non-
standard tones occur on the telephone line after going off hook (e.g. interrupted tone).
When this option is disabled, the control panel will start dialing the number 3 seconds after
going off hook, provided that the dial tone is present.
No answer tone test – if the option is enabled:
voice messaging: the voice message is played back 8 (first round) or 16 (next rounds)
seconds after completion of number dialing (the control panel does not check whether
the line is off-hook),
reporting: the control panel will ignore any signals (including the busy tone) received
from the telephone exchange after dialing the telephone number, and will wait for
the handshake from the monitoring station.
Enable this option if, after dialing the number, non-standard signals are received from
the telephone exchange or in case of very poor quality connections.
Store keyfob events – if the option is enabled, using the keyfob is written into the event log.
Trouble memory until review – if the option is enabled, the trouble memory is being
signaled until it is cleared (clearing the trouble memory is possible when you quit the
7. SYSTEM STATE user function).
Grade 2 – if the option is enabled, the system operates in accordance with the EN 50131
standard requirements for Grade 2, i.e.:
– the way of informing the users about the system state by means of LEDs, display and
beeps in the keypads meets the requirements of the standard (see: USER MANUAL),
– the quick arming from keypad (without entering the code) is not available,
– new codes in the system must be composed of at least 5 characters,
– prior to arming, the control panel checks that no circumstances have occurred that
prevent arming (ref. PREVENT ARMING IF NOT READY global option),
To Next Page
Loading...
