52 VERSA SATEL
Alarm 3 incorrect codes (mobile application) [Al.3 wrong codes] – if this option is enabled,
entering an invalid code three times from the VERSA CONTROL application will trigger an
alarm.
Push notifications – if this option is enabled, the VERSA CONTROL application can provide
information about alarm system events by means of push notifications.
Fig. 16. DLOADX program: configuring the ETHM-1 Plus module.
MAC – information on module hardware address.
ID – information on individual identification number for the purpose of communication via the
SATEL server (programming by means of DLOADX program, operating by means of
VERSA CONTROL application). The ID number is assigned automatically by the SATEL
server.
If the module is to be used in another alarm system, the hitherto used ID number must
be deleted. It can be done from the keypad, when programming the Ethernet module,
in the last step, if the control panel is connected to the SATEL server. Having deleted
the old ID number, the module will receive a new one. The VERSA CONTROL
applications using the old ID number will be unable to connect to the control panel.
IP – information on the module local / public address.
To Next Page