Section 2: Installation
CG2 Series Operator Manual Page 2-11
2.5 CONNECTIONS (cont’d)
2.5.2 Connecting the optional keypad
The optional keypad can be connected to the RS-232C terminal of the Type 1, CG2 Series printer, thus
providing a stand-alone feature. This feature enables users to enter simple commands flashes in red in long
intervals for the printer, by the connected keypad, without connecting to a host computer.
1. Make sure that power cable is not connected to the
printer.
2. Connect the cable from the optional keypad to the
RS232C terminal at the back of the printer.
Note:
Make sure the connector is correctly oriented. Secure
the printer with one hand, and insert the connector firmly.
3. Set the printer for use with the keypad. Refer to Section
3.5 Operation Setting Mode and perform the
procedures to set the printer to Keypad mode.
In step 4 of this procedure, briefly press of the FEED/
LINE button repeatedly until the ON LINE (POWER)
indicator has changed to display red in long intervals.
Note:
If Keypad is selected, even if the keypad device is not
connected, other interfaces cannot be activated.
2.5.3 Connecting the Power Cable
1.
Connect the AC power cable to the AC adapter.
Warning
• Be sure to connect the ground wire. Failure to do so may cause an electric shock.
• Do not operate the power switch or insert/remove the power cable while your hands are wet.
Doing so may cause an electric shock.
Caution
The power cable and the AC adapter provided with this printer are for use with this printer only.
They cannot be used with other electrical devices.
flashes red in a long interval
To Next Page
Loading...
Need help?
General
