SBC PCD2.M5 Series - Page 136

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Digital output modules
Input/output (I/O) modules
6-25
6
For every 2 outputs, a 3-colour LED is tted:
LED is
O0 O1 O2 O3 O4 O5 O6 O7 O8 O9 O10 O11 O12 O13 O14 O15
off 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Red 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0
Green 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1
Yellow 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
SBCprovidesawiderangeofpre-conguredcableswitha34-poleribbonconnector
at one or both ends.
These connection cables can be plugged at one end into the PCD2.E460 I/O module
and at the other end into an I/O terminal adapter.
The following adapters are obtainable from SBC:
terminal adapters for connecting 3-wire sensors to individual terminals for Signal,
PlusandMinus;terminaladaptersforconnecting16I/OswithandwithoutLEDand
relayinterface;andterminaladapterswithchangeovercontactsforsignalconversion
for digital output modules.
FurtherinformationcanbefoundintheManualon"System cables and connection system"
26/792.
The following materials can be ordered from ‘3M’:
●Socket connector 34-pole Type 3414-6600
●(Metalstrainrelief)*) Type 3448-2034
●(Handleforsocketconnector34-pole)*) Type3490-3
Matching cables can be ordered in reels from '3M':
●Ribbon cable 34-pole,
 greywithpin1identication Type3770/34or3801/34
●Round cable 34-pole,
 greywithpin1identication Type3759/34
*)optional