SBC PCD2.M5 Series - Page 191

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Analogue combined input/output modules
Input/output (I/O) modules
6-81
6
Conguration
Module connections/LEDs
The module connections are as follows:
Description of LED:
● Off: No power supply to module. U
ext
(24V)absent.
● On: Module working correctly.
● Flashingslowly: Channelerror(overload/underload/shortcircuit/
    openload)
● Flashingquickly: U
ext
lowerthanspecified(<19V).
Conguration of inputs
EachinputchannelisconguredviaaDIPswitchwithfourpins.Thefunctionofeach
pin is as follows:
Pin no. Off On
1
2
3
4
Differential mode
Gain=1
Single-ended mode
Current shunt resistance on
Supply to external resistors on
Gain=0,25
Accordingtothistable,thecongurationofthevariousoperatingmodesisasfollows:
Voltage mode
0...10 V
Current mode
0...20 mA
4...20 mA
Temperature mode
Pt1000 (-50...400 ˚C)
Pt500 (-50...400 ˚C)
Ni1000 (-60...200 ˚C)
Resistor mode
0...2500 Ω
1 2 3 4
On
Off
1 2 3 4
On
Off
1 2 3 4
On
Off
slider
Conguration of outputs
Astheoutputsareconguredusingsoftware(withtherelevantFBoxorFB),itis
notnecessarytoconguretheoperatingmodeoftheoutputsusingjumpersorDIP
switches.