SBC PCD2.M5 Series - Page 222

Hardware Manual for the PCD2.M5 Series│Document 26/856; Version EN 12│2014-07-24
Saia-Burgess Controls AG
Motion control modules for servo drives
Input/output (I/O) modules
6-112
6
Block diagram
Forfurtherinformation,pleaserefertomanual26/772,"PCD2.H32x-motioncontrolmod-
ules for servo-drives"
Watchdog: This module cannot be used on the base address 240, because it would
interact with the watchdog, and would cause a malfunction.
Fordetails,pleaserefertothe"Watchdog"section,whichdescribesthecorrectuse
of the watchdog in conjunction with PCD2 components.