Schenck process Intecont Satus - Page 103

Lever Ratio ...................................................................42
Lever Ratio ...................................................................35
Limit values ...................................................................45
Limit Values ...................................................................36
Load cell connection............................................................5,7
Load Cells .....................................................................7
Load preconfigured parameter ....................................................19
Load Preconfigured Parameters ...................................................33
M
Mains Failure ..................................................................17
Mains failure E1................................................................52
Maintenance and Service .........................................................2
Maximum H ...................................................................59
Meaning of the ‘Communication Host’ S9 event message .............................75,81
Measured values in integer format (Modbus) .........................................65
Measuring principle .............................................................13
Memory Error .................................................................36
Memory error S1 ...............................................................52
Minimum L ....................................................................60
MODBUS ...................................................................5,49
Modbus master settings .........................................................81
Modbus/TCP ..............................................................83-84
MODBUS/TCP.................................................................49
Modbus/TCP master settings .....................................................85
Moisture and Humidity............................................................2
Monitoring the Fieldbus channels ..................................................86
N
Namur inputs/pulse-output point ....................................................5
Network connection ..............................................................5
nominal belt load ...............................................................16
Nominal belt load ............................................................26,43
nominal belt load ..............................................................26
nominal feed rate...............................................................16
Nominal Feed Rate .............................................................40
nominal speed .................................................................23
Nominal Speed ................................................................40
Normal display.................................................................16
normal operation ...............................................................25
O
output impulses ................................................................30
Overview .....................................................................13
Overview of Parameters .........................................................35
P
Parameter Entry ...............................................................33
INTECONT® Satus Operating Manual BV-H2346GB / 0833 97
© Schenck Process