Schenck process Intecont Tersus Beltweigher User Manual

Mode functions
BV-H2464GB, 1234
- 26 -
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
Display:
▪ Event message SY14 Event: Simulation active
▪ One part of the actual value display in the upper display area is the line containing information on the
status and process of the program: Here 'SIM' signifies that Simulation Mode is active.
▪ This function can be turned off again with Stop Simulation in the same fashion.
Characteristics:
1. All operation functions can be executed
2. The actual feed rate is set at the setpoint feed rate for feeder systems. This value will be set as per
P02.02 Nominal Flow Rate for measuring systems.
3. Belt load and speed measuring are active for belt-based systems.
4. All inputs and outputs operate as set.

Schenck process Intecont Tersus Beltweigher Specifications

General

Brand	Schenck process
Model	Intecont Tersus Beltweigher
Category	Control Panel
Language	English