Schenck process Intecont Tersus Beltweigher User Manual

Parameters
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
BV-H2464GB, 1234
- 51 -
Note: An external binary output channel that may have been assigned to an event is set, independent of the
event class.
A newly pending alarm or warning 1-class event will be shown on the operating panel blinking and in color.
The blinking stops when acknowledged. Acknowledged event messages are cleared from the display for
currently pending events when the event is no longer pending. Each event is stored with a time-stamp in the
internal memory for later analysis.
13.3
13.313.3
13.3 Parameter Listing
Parameter Listing Parameter Listing
Parameter Listing
13.3.1
13.3.113.3.1
13.3.1 Parameter Ov
Parameter OvParameter Ov
Parameter Overview
erviewerview
erview
VBW20650-002 0802
01 - Dialog Behaviour
Number: Name Default Customer Sys ID
P01.01 [➙ 60]
Language * DEUTSCH 4224
P01.02 [➙ 60]
Userdefined Text * XX-NEW 5816
P01.03 [➙ 60]
Font * UMing 30 6244
P01.04 [➙ 60]
Units * Metric 4225
P01.05 [➙ 60]
Scale Name * INTECONT Tersus VBW 6238
P01.06 [➙ 60]
Password * 10000 4292
P01.07 [➙ 60]
2. Password * 14389 4321
P01.08 [➙ 60]
Feeder ON/OFF * active 4280
P01.09 [➙ 60]
Switch Keyboard-/Normal Mode * active 4282
P01.10 [➙ 60]
Batch control * active 4283
P01.11 [➙ 60]
>0: Zero ON/OFF * active 4284
P01.12 [➙ 60]
Reset Counter 1 * active 4286
P01.13 [➙ 60]
Reset Counter 2 * active 4287
P01.14 [➙ 60]
Route Tot. ON/OFF * not active 4308
P01.15 [➙ 60]
Data Log ON/OFF * not active 4309
02 - Rated Data
Number: Name Default Customer Sys ID
P02.01 [➙ 64]
Flow Rate Units ------ t/h 4229
P02.02 [➙ 64]
Nominal Flow Rate 400 t/h 4226
P02.03 [➙ 64]
Speed Measurement DI 6144
P02.04 [➙ 64]
Pulses per length 50.26 I/m 4256
P02.05 [➙ 64]
Nominal Speed 1 m/s 4227

Schenck process Intecont Tersus Beltweigher Specifications

General

Brand	Schenck process
Model	Intecont Tersus Beltweigher
Category	Control Panel
Language	English