Schenck process Intecont Tersus Beltweigher User Manual

Safety notes
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
BV-H2464GB, 1234
- 3 -
2
22
2 Safety notes
Safety notesSafety notes
Safety notes
To avoid personal injury and material damage, follow the safety regulations stated below.
Additionally you should also observe:
▪ Safety information given in order-specific documentation
▪ Safety information relating to mechanical components
▪ Instructions and safety instructions for parts manufactured by thrid-party suppliers or parts that are not
part of Schenck's scope of delivery.
When performing installation, commissioning and service work, observe all applicable local regulations.
Intended Application
Intended ApplicationIntended Application
Intended Application
The measuring system and its connected mechanical components are exclusively designed for weighing
and controlling tasks. Any use other than originally intended is considered inappropriate.
Sources of Risk
Sources of RiskSources of Risk
Sources of Risk
If the measuring system has been correctly installed and commissioned, it does not pose any danger during
weigh operations.
Hazards may arise when the system is used for control operations or for transporting weighed goods. Po-
tential hazards may then arise from e.g. additional devices through which the weighed goods are passed or
metered. Minor risks may arise in these situations if the measuring system is used or operated by untrained
personnel.
The measuring system can be part of a more complex plant. The system operating company is fully respon-
sible for the operating safety of the system.
Personnel
PersonnelPersonnel
Personnel
Preparation, assembly, commissioning, operation, maintenance and servicing may only be carried out by
qualified personnel.
All persons working on the system are required to observe the safety hints and know the parts of the tech-
nical documentation relevant to their work.
The operating company is responsible for instructing his operators to observe all regulations and instruc-
tions given.
Changing Parameters
Changing ParametersChanging Parameters
Changing Parameters
The measuring system's functionality is determined by parameters. Only personnel familiar with the device's
mode of operation may alter these parameters (e.g. after training by Schenck Process). Incorrectly set pa-
rameters may cause injury or material damage. Furthermore they may also cause considerable disruption to
weigh operations.
Password
PasswordPassword
Password
Passwords safeguard the parameters against unauthorized alteration. The measuring system operating
company must ensure that the password is handled safely.
Acknowledging Event Messages
Acknowledging Event MessagesAcknowledging Event Messages
Acknowledging Event Messages
Error messages may be acknowledged only after cause of fault has been remedied.
Ensure that any connected peripheral devices are functioning correctly before acknowledging an event. Any
connected control systems in particular must be in safe state.

Schenck process Intecont Tersus Beltweigher Specifications

General

Brand	Schenck process
Model	Intecont Tersus Beltweigher
Category	Control Panel
Language	English