Schenck process Intecont Tersus Beltweigher User Manual

Parameters
BV-H2464GB, 1234
- 92 -
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
13.3.2.16
13.3.2.1613.3.2.16
13.3.2.16 Parameter Block
Parameter BlockParameter Block
Parameter Block 16
1616
16 -
--
- Digital Inputs
Digital InputsDigital Inputs
Digital Inputs
The parameters in this group are used to associate various controller functions with specific digital input
channels and to associate events with those functions. Most of the functions specified in this group are hard
wired on the controller and cannot be changed.
P16.01 Source Run Enable
Default: DI VCU1.DI3 High
Alternative: DI
FB
n/a
Determines the signal input that gives the scales release signal. This input is generally
used for interlocking with downstream transport equipment.
The setting 'n/a' means that no release is required.
P16.02 DI: Batch Terminate
Default: n/a
Alternative: n/a
DI
Digital input signal for stopping a current batch.
P16.03 DI: Acknowledge Events
Default: DI VCU1.DI1 High
Alternative: DI
n/a
Digital input for acknowledging event messages.
Caution: the level is static and may not be on permanently (otherwise continuous acknowl-
edgement).
P16.04 DI: Start
Default: n/a
Alternative: n/a
DI
If OP is selected as the turn-on source, the digital input that the scale can be started with
using a turn-on impulse can be configured here in parallel to the ON/OFF buttons on the
keyboard.
The scale is turned off by an impulse on the digital input P16.01 Source Run Enable.
P16.05 DI: Zero Set
Default: n/a
Alternative: n/a
DI
Input channel for starting the zeroing program with an empty belt.

Schenck process Intecont Tersus Beltweigher Specifications

General

Brand	Schenck process
Model	Intecont Tersus Beltweigher
Category	Control Panel
Language	English