Parameters
BV-H2464GB, 1234
- 62 -
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
P01.06 Password
Default: 10000
Min: 1000 Max: 9999
Password 1 for access protection of certain functions on the operator panel as per the fol-
lowing parameters. Usually the 1st password is used for the service personnel and the 2nd
password for operating personnel with particular privileges. The password keyed in is
shown encoded for protection. The password can be reset using EasyServe if it should be
forgotten.
The password set at the factory: 7353
P01.07 2. Password
Default: 14389
Min: 1000 Max: 9999
Password 2 for access protection for certain functions on the operator panel as per the
following parameters. Usually the 1st password is used for the service personnel and the
2nd password for operating personnel with particular privileges. The password entered is
shown encoded on the screen. The password can be reset using EasyServe if it should be
forgotten.
The password set at the factory: 2889
P01.08 Feeder ON/OFF
Default: active
Alternative: active
not active
Password
2.Password
Confirm
Defines the access protection for using the operating console.
Using this parameters, access to the basic function prefeeder ON/OFF can be controlled.
The following options are available:
active: Access is always permitted.
not active: Access is never allowed. This function is not visible in the block.
Password: Access is available with the standard password.
2nd password: Access is available with the 2nd password.
Confirm: The access must be confirmed for security reasons.
Note: The prefeeder also has to be activated via parameters.
P01.09 Switch Keyboard-/Normal Mode
Default: active
Alternative: active
not active
Password
2.Password
Confirm
Defines the access protection for using the operating console.
To Next Page
Loading...
Need help?
General
