Schenck process Intecont Tersus Beltweigher User Manual

Parameters
BV-H2464GB, 1234
- 86 -
INTECONT® Tersus Belt weigher, Instruction Manual
Schenck Process Group
P13.12 Event: Belt Skew
Default: A
Event Group: WM Number: 03
Belt has run off-center. Feeder is no longer operable.
Action: See Event: Belt Drift
Related threshold: Belt Skew
P13.13 Slip Value
Default: 2 % LB
Min: 0 % LB Max: 10 % LB
The permitted change in length of the conveyor belt in % of the total belt length.
There is a Event: Slip event message if it exceeds the limit
and the P13.17 DO: Belt Slip digital output is set.
P13.14 Event: Slip
Default: W1
Event Group: WM Number: 02
This event is identified if the belt motion does not correspond to that predicted by the motor
revolutions.
Possible causes:
- belt is slipping at the drive pulley
- withdrawal forces are too high
- gearing is defective
- belt or drive pulley heavily soiled
Steps:
- visual inspection of the belt and the bulk material flow
P13.15 DO: Belt Drift
Default: n/a
Alternative: n/a
DO
The digital output to show the event of drift.
Also refer to: P13.09 Belt Drift and P13.10 Event: Belt Drift
The output operates independently of the event class of the corresponding event.
P13.16 DO: Belt Skew
Default: n/a
Alternative: n/a
DO
Digital output for displaying the belt motion event.
Also refer to: P13.11 Belt Skew and P13.12 Event: Belt Skew
The output operates independently of the event class of the corresponding event.

Schenck process Intecont Tersus Beltweigher Specifications

General

Brand	Schenck process
Model	Intecont Tersus Beltweigher
Category	Control Panel
Language	English