Checkup
Cable with Terminals
The cable with terminals has to be checked for breaks of wires and braids.
The cable with terminals has to be replaced:
• within the scheduled maintenance intervals ( Chapter #11.2).
• if more than 10 single wires are broken.
• if 1 single braid is broken.
Checkup:
1. Completely raise pantograph.
2. Check cable over its whole length for damage:
3. Check, if the contact surfaces to lower frame, cams and cable guide are well-
greased.
Illustration 20: EXAMPLE: Grease cable with terminals
4. Grease cable with terminals ( Chapter #11.3.3).
Replace damaged components if necessary ( Chapter #11.5.1).
To Next Page
