SciCan Bravo - 4. Installation; Dimensions and Weight; Compartment Dimensions for Built-in Installations

4. INSTALLATION
10.
4. INSTALLATION
DIMENSIONS AND
WEIGHT
Correct and careful installation will ensure your Bravo functions properly, protects operators
from physical injury and protects property from damage.
– Height (all models) 16.5” / 420 mm
– Width (all models) 19” / 480 mm
– Depths (excluding rear connections)
Bravo
17
, Bravo
17V
22.0” / 560 mm
Bravo
21V
25.0” / 635 mm
– Total weights (with rack and trays)
Bravo
17
: 121 lbs / 55 kg
Bravo
17V
: 128 lbs / 58 kg
Bravo
21V
: 139 lbs / 63 kg
Electricity
The electrical system to which the sterilizer will be connected must accommodate the electrical
characteristics of this device. This information is shown on the back of the machine.
COMPARTMENT
DIMENSIONS FOR
BUILT-IN
INSTALLATIONS
When installing the sterilizer inside a cabinet, you
must provide adequate space all around the device
to provide effective ventilation. There should also be
an opening in the back large enough to provide
adequate air flow. This will allow optimum cooling of
the heat exchanger.
A built-in compartment MUS T have the minimum
dimensions shown in the figure at right.
– Height (all models) 18.5” / 490 mm
– Width (all models) 23” / 580 mm
– Depths
Bravo
17
, Bravo
17V
26” / 660 mm
Bravo
21V
29” / 735 mm
WARNING
COMPARTMENT DIMENSIONS LESS THAN THOSE SH O WN M A Y
COMPROMISE THE CORRECT CIRCULATION OF AIR AROUND THE
DEVICE AND MAY NOT PROVIDE ADEQUATE COOLING. THIS CAN
RESULT IN THE DETERIORATION OF PERFORMANCE AND/OR POSSIBLE
D AM A GE.
NOTE
DO NOT REMOVE THE UPPER COVER OR ANY OTHER EXTERNAL PART. WHEN INSTALLED
IN THE COMPARTMENT, THE DEVICE MUST BE COMPLETE WITH ALL ITS P AR T S .
PLEASE REFER TO APPENDIX A (TECHNICAL CHARACTERISTICS) FOR COMPLETE
TECHNICAL DATA.