SciCan Bravo - Setting the sterilization programs

6. CONFIGURATION
24.
NOTE
TO CHANGE THE PASSWORD, FIRST SELECT THE DISABLE OPTION, WHICH CANCELS
THE PREVIOUS PASSWORD, AND THEN SELECT THE AN Y POWER-ON OR ANY
CYCLE START OPTION, ENTERING THE NEW PASSWORD AS DESCRIBED ABOVE.
Setting the sterilization
programs
(PROGRAMS on the
ADVANCED menu)
Setting and storing customized sterilization programs in the four pre-set positions can be
completed by following these steps, starting in the advanced menu.
Each pre-set position can be associated to a standard or user configurable cycle (CUSTOM).
To associate a standard program and define several of its parameters, proceed as follows:
1. Select PROGRAMS using the ↵ key; the following menu appears:
→ 1st PRESET +
2nd PRESET ↑
3rd PRESET ↓
4th PRESET -
EXIT
Define the position (1, 2, 3 or 4) to which the sterilization program will be associated using
the + and - keys. Confirm with the ↵ key.
2. From here, you enter the list of available cycles:
→ 134 H OLLOW/UNWRAP.+
1 21 HOLLOW/UNWRAP.↑
134 SOLID/UNWRAP. ↓
121 SOLID/UNWRAP. -
134 EMERGENCY
134 SOLID/WRAPPED
121 SOLID/WRAPPED
134 POROUS/WRAPPED
121 POROUS/WRAPPED
XXX CUSTOM
EXIT
Using the + and - keys, scroll the list until you identify the sterilization program desired.
3. Confirm the selection with the ↵ key.