SciCan Bravo - Page 31

6. CONFIGURATION
25.
As a function of the choices made, you will go to one of two alternative menus that allow you to
choose the type of drying you want associated with the selected program.
a) Programs with short drying (HOLLOW/UNWRAP., SOLID/UNWRAP., EMERGENCY):
→ STANDARD DRYING +
FAST DRYING ↑
EXIT ↓
-
The default setting is STANDARD mode. Move using the + and - keys and confirm with the
↵ key.
NOTE
THE EMERGENCY PROGRAM PROVIDES ONLY F A ST DRYING (SUITABLE FOR A LOAD
UP TO 0.5 KG/1.1 LBS).
b) Programs with long drying (POROUS/WRAPPED, SOLID/WRAPPED, EXTRA ):
→ STANDARD DRYING +
INTELL. DRYING ↑
EXTRA DRYING ↓
EXIT -
The default setting is STANDARD. Also available are the INTELLIGENT option, an
automatic drying that adjusts its duration on the basis of the volume and/or quantity and
type of load, and the EXTRA option, a selectable value extended drying recommended for
critical loads. Move using the + and - keys and confirm with the ↵ key.
WARNING
THE FAST, INTELLIGENT A N D EXTRA DRYING OPTIONS HAVE NOT BEEN
V A L I D A T E D A N D H A V E N OT BEEN CLEARED IN THE U.S. BY FDA FOR
HEALTHCARE USE.
PLEASE REFER TO THE “PROGRAM SUMMARY T AB L E” AND ITS GENERAL
NOTES (SEE APPENDIX B – PROGRAMS) FOR A DESCRIPTION OF THE DRYING OPTIONS
AND THE MAXIMUM STERILIZABLE MASS ALLOWED IN EACH STERILIZATION PROGRAM.
When the EXTRA option is activated, the following screen appears:
EXTRA: XX min
+/- to set
↵ to enter
⇑ to exit
This option permits adding between 1 and 15 minutes of extra drying time to the
STANDARD DRYING time). Set the value using the + and - keys and confirm the selection
with the ↵ key.
NOTE
THE SELECTION CAN BE CHANGED AT ANY TIME BY FOLLOWING THE PROCEDURE
DESCRIBED ABOVE.
WHEN AN IDENTICAL STERILIZATION PROGRAM IS ALREADY PRESENT IN ANOTHER
POSITION, THE SELECTION IS NOT ACCEPTED. THE FOLLOWING WARNING APPEARS ON
THE DISPLAY, ALONG WITH A BEEP:
THIS PROGRAM
IS ALREADY PRESET