Shimadzu GC-2014 Operation Manual

3.2 Analysis using packed column
48
4
Stop the GC.
(1) Press .
If you press when the GC status is
[SYSTEM On], the screen in the right figure
appears.
(2) Press [Stop GC] (PF1 key) to stop the instrument.
The GC stops by following the GC stop
sequence.
CAUTION
NEVER turn off the GC power when the temperature of each component is still high. In particular,
turning off the power even though the column oven temperature is still high, it may damage your
columns since the carrier gas is automatically shut off.
In case of manual flow controller, the flame of the FID will not be extinguished since the detector gas is
still supplied even after turning the power OFF. Stop the hydrogen gas supply to extinguish the FID
flame without fail.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)