4.1 Parts for maintenance
80
4.1 Parts for maintenance
If you are using packed column
Septum
Glass insert (needed when applying "glass insert method")
Seal materials
Column
(You can install two of 14G type column which is 3 m or longer at the same time.)
** SUS column: 05, 10, 15, 20, 25, 30, 35, 40, 45, 50, 60
7G 3.2: 11, 16, 21, 26, 31, 36, 41, 46, 51
7G 2.6: 11, 16, 21, 26, 31, 36, 41, 46, 51
14G: 31, 36, 41, 46, 51
1/10 of above values signify the length of columns (m).
For column packing material and packed columns, see packing supplier's catalogs.
The following is the list of maintenance parts and their part numbers. All these parts are consumables.
For part numbers prefixed with "S", Shimadzu products are recommended.
Name Part No. Purpose
Silicon rubber septum (20 pcs) S201-35584 Inlet septum
Name Part No. Purpose
Glass insert 3.2 mm S221-14093
For 3.0 to 3.4 mm glass column
SUS column
Glass insert 2.6 mm S221-14094 For 2.4 to 2.8 mm glass column
Name Part No. Purpose
Graphite ferrule (4 pcs)
S221-15563-91
Glass column installation
Silicon O-ring (20 pcs) S201-47614 Glass column installation
Aluminum gasket (100 pcs) S201-35183-84 SUS column installation
Silicon rubber gasket (50 pcs) S201-35184 SUS column installation
Name Part No. Purpose
SUS column 201-48705-
Stainless empty column
(3 mm inside diameter, 4 mm outside diameter.)
Glass column 4MG3-05 S221-00838-05
Glass empty column, 3.2 mm inside diameter, 0.5 m
long
Glass column 4MG2.6-05 S221-00838-05
Glass empty column, 2.6 mm inside diameter, 0.5 m
long
Glass column 7G 3.2 221-14368- Glass empty column, 3.2 mm inside diameter
Glass column 7G 2.6 221-13008- Glass empty column, 2.6 mm inside diameter
Glass column 14G 221-34393- Glass empty column, 3.2 mm inside diameter
To Next Page
Loading...
Need help?
General
