Shimadzu GC-2014 Operation Manual

3.3 Analysis using capillary column
66
 Setting for analysis
1
Specify GC configuration.
(1) Press key.
(2) Select 6. GC Configuration
(3) Select 9. Other Configuration.
(4) Select "DAFC unit" as "AMC. LR".
2
Verify line configuration.
Press [Line Confg] (PF2 key) in the [SET] key main
screen, and verify the units are configured on an
analytical flow line.
NOTE
Perform this operation only when you are using GC-
2014 AFSPL, ATFSPL.
You can use the dual AFC connected to the dual packed
INJ as AMC for makeup gas.
(Left side is AMC.L, and right side is AMC.R)
NOTE
If the computer is connected, (1) specify the DAFC unit
setting on the GC, (2) start up the application, (3)
perform line configuration on the computer.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)