Shimadzu LC-10 User Manual

4 Using the control module Clarity Controls
Sampling Rate
Sets the sampling rate of the detector. The available detector sample rates
are dependent on the Base Period settings on the Shimadzu LC-10/20
System Setup - Detector tab - by using the shortest Base Period of 20 ms,
the Sampling Rate can be set up to 50 Hz. Please note that in dual mode
the Base Period is limited to 100 ms and maximum Sampling Rate to 10
Hz.
Cell Temperature
Sets the cell temperature of the given detector. The Value range is
between 9 and 50 °C.
Check Cell Temperature
If checked, doesn't allow the Instrument to become READY until the
temperature is not close to the temperature set in the Cell
Temperature field (with the tolerance of 1,5 °C).
- 33 -

Shimadzu LC-10 Specifications

General

Brand	Shimadzu
Model	LC-10
Category	Laboratory Equipment
Language	English