SICK DL100 Pro - PROFINET IO High Feature - Page 67

8021823/126P/2018-12-17 • © SICK AG • Subject to change without notice 67
Operation via Ethernet (Ethernet interface)
Field "Heater" Requirements for the display
• Devices with the option "Heating" (DL100-xxHxxxxx)
Parameter Description
Heater thresh-
old
Enter power up threshold for heating.
Read/Write access
• Read and write
Input value
• –10...+40
Unit
• °C
Factory setting
• –10
Table 44: Page "Parameter settings" – eld "Heater"
Field "Frequency" Requirements for the display
• Devices with the option "Frequency" (DL100-xxxBxxxx)
Parameter Description
Freqency set Select frequency range.
Read/Write access
• Read and write
Input value
• 0: Mode 1 / 1: Mode 2 / 2: Mode 3
Unit
• °C
Factory setting
• –10
Table 45: Page "Parameter settings" – eld "Frequency"
Field "Store parameter"
Parameter Description
Storage
Parameterchangesonlyenterintopermanenteectif
they are saved via the button "Storage".
Read/Write access
• Write only
Table 46: Page "Parameter settings" – eld "Store parameter"
Field "Set parameters to
default values"
Parameter Description
Parameter
Reset
Click the button "Parameter Reset" to reset the parameters to
factory settings.
Read/Write access
• Write only
Table 47: Page "Parameter settings" – eld "Set parameters to default values"