Siemens 6RA7086-6KS22

05.05 Contents
Siemens AG 6RX1700-0AD76 0-3
SIMOREG DC Master Operating Instructions
Page
5.2.5 Converters: 3AC 460V, 60A to 125A, 4Q 5-22
5.2.6 Converters: 3AC 460V, 210A to 280A, 4Q 5-23
5.2.7 Converters: 3AC 460V, 450A to 600A, 4Q 5-24
5.2.8 Converters: 3AC 460V, 850A, 4Q 5-25
5.3 Mounting options 5-26
5.3.1 Terminal expansion board CUD2 5-26
5.3.2 Optional supplementary boards 5-27
5.3.2.1 Local bus adapter (LBA) for mounting optional supplementary boards 5-27
5.3.2.2 Mounting of optional supplementary boards 5-27
6 Connections
6.1 Installation instructions for proper EMC installation of drives
6-2
6.1.1 Fundamental principles of EMC 6-2
6.1.1.1 What is EMC 6-2
6.1.1.2 Noise radiation and noise immunity 6-2
6.1.1.3 Limit values 6-2
6.1.1.4 SIMOREG converters in industrial applications 6-3
6.1.1.5 Non-grounded supply systems 6-3
6.1.1.6 EMC planning 6-3
6.1.2 Proper EMC installation of drives (installation instructions) 6-4
6.1.2.1 General 6-4
6.1.2.2 Rules for proper EMC installation 6-4
6.1.2.3 Converter component arrangement 6-13
6.1.2.4 List of the recommended radio interference suppression filters 6-14
6.1.3 Information on line-side harmonics generated by converters in a
fully-controlled three-phase bridge circuit configuration 6-15
6.2 Block diagrams with recommended connection 6-17
6.2.1 Converters: 15A to 125A 6-17
6.2.2 Converters: 210A to 280A 6-18
6.2.3 Converters: 400A to 3000A with a 3-phase fan 6-19
6.2.4 Converters: 450A to 850A with a 1-phase fan 6-20
6.3 Parallel connection of converters 6-21
6.3.1 Circuit diagram showing parallel connection of SIMOREG converters 6-21
6.3.2 Parameterization of SIMOREG converters for parallel connection 6-22
6.3.2.1 Standard operating mode 6-22
6.3.2.2 Operating mode "N+1 mode" (redundancy mode of the armature supply) 6-23
6.3.2.3 Redundancy mode of the field supply 6-25
6.4 Power connections 6-26
6.4.1 Converters: 30A, 1Q 6-26
6.4.2 Converters: 60A, 1Q 6-27