The use of unauthorized parts in the repair of the equipment or tampering by
unqualified personnel will result in dangerous conditions which will cause severe
personal injury or equipment damage. Follow all safety instructions contained
herein.
IMPORTANT
The information contained herein is general in nature and not intended for specific
application purposes. It does not relieve the user of responsibility to use sound
practices in application, installation, operation, and maintenance of the equipment
purchased. Siemens reserves the right to make changes at any time without
notice or obligations. Should a conflict arise between the general information
contained in this publication and the contents of drawings or supplementary
material, or both, the latter shall take precedence.
QUALIFIED PERSON
For the purposes of this manual, a qualified person is one who is familiar with the
installation, construction, or operation of the equipment and the hazards involved.
In addition, that person has the following qualifications:
(a) is trained and authorized to de-energize, clear, ground, and tag circuits and
equipment in accordance with established safety practices.
(b) is trained in the proper care and use of protective equipment such as rubber
gloves, hard hat, safety glasses, or face shields, flash clothing,etc., in
accordance with established safety procedures.
(c) is trained in rendering first aid.
SUMMARY
These instructions do not purport to cover all details or variations in equipment, nor to provide for every possible
contingency to be met in connection with installation, operation, or maintenance. Should further information be
desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the
matter should be referred to the local sales office.
The contents of the instruction manual shall not become part of or modify any prior or existing aggreement,
commitment or relationship. The sales contract contains the entire obligation of Siemens Energy & Automation,
Inc. The warranty contained in the contract between parties is the sole warranty of Siemens Energy &
Automation, Inc. Any statements contained herein do not create new warranties or modify the existing warranty.
This manual supercedes PRIM-2330B-0199. There are only
formatting/structural changes.
To Next Page
Loading...
