Siemens 7UT51 User Manual

15
Operation Using a Personal Computer
7UT51 v3
154 PRIM-2330C
15.2 Programming the Relay
Programming of the relay with a PC and WinDIGSI
software is straight forward since it is Windows based;
however, consult the Siemens
WinDIGSI User’s
Manual
for detailed instruction if necessary.
When using a PC to set the parameters, it is best to
enter the data as you page through the screens rather
than programming for particular functions. The
following parameters must be entered to enable the
relay to respond accurately with tripping, alarms,
measurements, and event recording, etc. Use the
completed Relay Setting Sheets (available in Chapter
19) to expedite with the programming process.
Before programming begins, the entry of the following
information is required:
•Enter
User Name
• Choose NEW Substation
• Enter the
Destination Directory
• Enter the Substation Address
• Enter the Feeder Name
• Enter the Device Name
• Enter the Device Address
• Enter the Ordering Code
• Choose the menu option DIALOG
• Choose with file or with protective device direct
WinDIGSI then opens a new screen with the following
menu options:
• Parameter (describe in detail in Section 15.3 on
page 154)
- Configuration Menu
- Marshalling Menu
- Settings Menu
• Control
• Annunciations
• Fault
• Options
-Interface
- Response Time
- Delete device files
- Transmit with/without saving
- Modify baud rate
- Command archive
- Date/Time
- Reset LEDs
- Initiate fault record
•Help
15.3 Parameter Menu
The following Parameter menu choices are shown for
a 7UT513 with restricted ground-fault option and with
isolated serial interface option. Menu options will
change depending on the model selected and the
device
Enabled
and set to
On
. If you are not certain
about the proper parameter settings to use, it is best to
keep it at the factory setting.
15.3.1 Configuration Menu
Local User Interface (Address Block 7100)
• Address 7101 – Language
• Address 7102 – Date Format
• Address 7105 – Top Line of Display Under Normal
Conditions
• Address 7106 – Bottom Line of Display Under
Normal Conditions
• Address 7107 – Top Line of Display After Fault
• Address 7108 – Bottom Line of Display After Fault
• Address 7110 – Update LEDs/display (with pickup
or with trip.

Siemens 7UT51 Specifications

General

Brand	Siemens
Model	7UT51
Category	Relays
Language	English