© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
ACCESS 9340 and 9360 Meters PMCM-9340D-0208
Chapter 1—Introduction 2/2008
EN–2
Topics Not Covered in This Manual
Some of the meter’s advanced features, such as onboard data logs
and alarm log files, can only be set up over the communications link
using ION setup or WinPM.Net from Siemens. This meter instruction
bulletin describes these advanced features, but does not explain how
to set them up. For instructions on using ION setup or WinPM.Net,
refer to the appropriate online help, User Guide, or Commissioning
Guide.
NOTE: The ACCESS 9340/9360 Meter is supported only by ION
setup 2.1 SP1 or higher and WinPM.Net 3.2 SP1 or higher.
To Next Page
Loading...
