© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
PMCM-9340D-0208 ACCESS 9340 and 9360 Meters
2/2008 Chapter 8—Logging
EN–93
CHAPTER 8—LOGGING
Introduction
This chapter briefly describes the following logs of the meter:
• Alarm log
• Maintenance log
• Billing log
• User-defined data logs
See the table below for a summary of logs supported by each meter.
Logs are files stored in the nonvolatile memory of the meter and are
referred to as “onboard logs.” The amount of memory available
depends on the model (see Table 8–2). Data and billing log files are
preconfigured at the factory. You can accept the preconfigured logs
or change them to meet your specific needs. Use WinPM.Net to set
up and view all the logs. See the WinPM.Net online Help for
information about working with the meter’s onboard logs.
Waveform captures are stored in the meter’s memory, but they are
not considered logs (see Chapter 9—Waveform Capture on
page103). Refer to “Memory Allocation for Log Files” for information
about memory allocation in the meter.
Table 8–1: Number of logs supported by model
Log Type
Number of Logs Per Model
9340 9360
Alarm Log 1 1
Maintenance Log 1 1
Billing Log 1 1
Data Log 1 1 1
Data Log 2 — 1
Data Log 3 — 1
Table 8–2: Available Memory for Onboard Logs
Meter Model Total Memory Available
9340 80 KB
9360 800 KB
To Next Page
Loading...
