© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
ACCESS 9340 and 9360 Meters PMCM-9340D-0208
Chapter 3—Operation 2/2008
EN–30
Set Up the Power Demand Configuration
Set Up the EN50160 Evaluation
1. Press
###: until DMD is visible.
2. Press DMD.
3. Select the demand configuration. Choices
are COMMS, RCOMM, CLOCK, RCLCK,
IENGY, THERM, SLIDE, BLOCK, RBLCK,
INPUT, and RINPUT.
4. Press OK.
5. Enter the INTVL (interval) and press OK.
6. Enter the SUB-I (sub-interval) and press
OK.
7. Press
1; until you are asked to save your
changes.
8. Press YES to save the changes.
PLSD110232
1. Press ###: until 50160 is visible.
2. Press 50160.
3. Select ON.
4. Press OK.
5. Change the nominal voltage (NOM V)
value if desired (230 is the default).
6. Press OK to return to the SETUP MODE
screen.
7. Press
1; until you are prompted to save
your changes.
8. Press YES to save your changes and
reset the meter.
PLSD110316
To Next Page
Loading...
