© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
ACCESS 9340 and 9360 Meters PMCM-9340D-0208
Chapter 11—Maintenance and Troubleshooting 2/2008
EN–116
Troubleshooting
The information in Table 11–1 on page 117 describes potential
problems and their possible causes. It also describes checks you can
perform or possible solutions for each. After referring to this table, if
you cannot resolve the problem, contact the your local Siemens sales
representative for assistance.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC
FLASH
Failure to follow this instruction will result in death or
serious injury.
• Apply appropriate personal protective equipment (PPE) and
follow safe electrical practices. For example, in the United States,
see NFPA 70E.
• This equipment must be installed and serviced only by qualified
personnel.
• Turn off all power supplying this equipment before working on or
inside.
• Always use a properly rated voltage sensing device to confirm
that all power is off.
• Carefully inspect the work area for tools and objects that may
have been left inside the equipment.
• Use caution while removing or installing panels so that they do
not extend into the energized bus; avoid handling the panels,
which could cause personal injury.
To Next Page
Loading...
