© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
ACCESS 9340 and 9360 Meters PMCM-9340D-0208
Chapter 3—Operation 2/2008
EN–36
Check the Health Status
Read and Write Registers
1. Press MAINT. (maintenance).
2. Press DIAG. The health status is
displayed on the screen.
3. Press
1; to return to the MAINTENANCE
screen.
NOTE: The wrench icon and the health status
code displays when a health problem is
detected. For code 1, set up the Date/Time
(see “Set Up the Date” and “Set Up the Time”
on page 19). For other codes, contact
technical support.
PLSD110191
1. On the HEALTH STATUS screen, Press
REG (register).
2. Enter the password (the default is 0000).
3. Enter the REG. (register) number.
The HEX (hexadecimal) and DEC
(decimal) values of the register number
you entered displays.
4. Press OK.
5. Enter the DEC number if necessary.
6. Press
1; to return to the DIAGNOSTICS
screen.
NOTE: For more information about using
registers, see Appendix A—Meter Register
List on page 119.
PLSD110194
To Next Page
Loading...
Need help?
General
