© 2008 Siemens Energy & Automation, Inc. All Rights Reserved.
PMCM-9340D-0208 ACCESS 9340 and 9360 Meters
2/2008 Chapter 3—Operation
EN–25
Set Up the Passwords
Set Up the Operating Time Threshold
1. Press
###: until PASSW (password) is
visible.
2. Press PASSW.
3. Enter the SETUP password.
4. Press OK.
5. Enter the DIAG (diagnostics) password.
6. Press OK.
7. Enter the ENERG (energy reset)
password.
8. Press OK.
9. Enter the MN/MX (minimum/maximum
reset) password.
10. Press OK.
11. Press
1; until you are asked to save your
changes.
12. Press YES to save the changes.
PLSD110224
1. Press ###: until TIMER is visible.
2. Press TIMER.
3. Enter the 3-phase current average.
NOTE: The meter begins counting the
operating time whenever the readings are
equal to or above the average.
4. Press OK.
5. Press
1; until you are asked to save your
changes.
6. Press YES to save the changes.
PLSD110257
To Next Page
Loading...
